XRT Hydramist Kit

[west_minist]

Hydramist-fb-s[1].jpg (138.14 KiB) Viewed 1107 times

HydramistDDS3[1].jpg (26.07 KiB) Viewed 1115 times

W.Injection = Display's when system is on
Water Level = Illuminates when water level is low. Pump will be turned off
Flow = Shows flow from water flow sensor
B = Illuminates when Hydra Auxiliary Maps are enabled
SC = Adjusts the range of flow display
WL = Water flow low fault
WH = Water flow high fault

Hydramist Kit
Element Hydramist Kits Include:

- 150W Hydramist Pump with 125psi By-Pass valve
- 22cc Surge Arrestor Assembly
- HSV (High Speed Water Injection Valve)
- Hydramist Waterflow Guage Kit
- Water Level Sensor
- Water Jets, 0.8mm, 0.9mm and 1mm
- Water Tank Adaptor
- Hydramist Wiring Harness
- M8 Tap (For water jet)
- 5M of 6mm High Pressure Water/Methanol Line
- 2M of 4mm High Pressure Water/Methanol Line
- Stainless 100 Micron Filter
- 40A Pump Relay
- Hydramist Wiring Diagram

Cost $800usd

Generic pricing, exclusive of shipping

[sub-zero]

Whats that for?

[west_minist]

Its for water injection. In essence, more power, safer running.

Required Installation Tools Not Supplied:

- Assorted Metric Open Ended Wrenches
- Wire Stripper
- Wire Crimper
- Razor Blade
- Drill and Drill Bits
- 17/64 drill bit for M8 tap (M8 tap supplied)
- Screw Drivers

Required Parts Not Supplied:

- Zip Ties
- 16 ft 8 Gauge Wire (Recommendation: Car Stereo Amp Wiring Kit)
- 40 Amp Fuse
- 4 Bolts and 4 nuts

[west_minist]

This unit can be run without the Hydra EMS, using a boost switch.

[west_minist]

Element Hydramist Water/Methanol Injection System Installation Guide